“Zno Plus – Reinforced zinc oxide – eugenol restorative material designed for intermediate restorations” has been added to your cart. View cart

-51% Off

Iono Lute+ Glass Ionomer Luting Cement GIC

Original price was: Rs.910.00.Current price is: Rs.450.00.

Category: Conservative

Excellent Adhesion: Strong bond to dentin and enamel, ensuring secure retention of restorations.
Fluoride Release: Continuous fluoride release that helps prevent caries and strengthens tooth structure.
Low Post-Operative Sensitivity: Minimizes discomfort for patients after procedures.
Quick Mixing and Setting: Fast mixing time (0.45 seconds) and short setting time (3:30 minutes) for efficient clinical use.
Versatile Applications: Suitable for cementing inlays, crowns, bridges, orthodontic bands, and as a base or liner in cavity preparations.
Good Flowability: Easy to handle and apply, allowing for precise placement.
Biocompatibility: Safe for use in dental applications with minimal irritation to surrounding tissues.
Consistency and Stability: Reliable performance under a variety of clinical conditions.

Expected Timings: 25 C [higher temperature would reduce timings]
Mixing: 25 sec
Working Time: 1Min 30 sec
Initial Set fintra orall 6 min from the start of mixing.
Store at temperature of 25 C. (Shelf life: 3 years) protect from moisture and sunlight.
Shades: Matching to A-2
Shelef Life: 3 years from the date of Manufacturing.

Composition:

Preparation:
- Ensure the tooth surface and restoration are clean and free of debris.
- Isolate the area to prevent moisture interference during application.
Mixing:
- Shake the liquid bottle thoroughly.
- Dispense 1 level scoop of powder and 2 drops of liquid onto a mixing pad.
- Mix the powder and liquid for approximately 0.45 seconds until a homogenous consistency is achieved.
Application:
- Use an applicator or spatula to apply the mixed cement evenly to the internal surface of the restoration.
- Seat the restoration firmly onto the prepared tooth structure.
Adjustments:
- Make any necessary adjustments to occlusion and proximal contacts immediately after seating the restoration.
Setting:
- Allow the cement to set for approximately 3 minutes and 30 seconds at 23°C. Avoid disturbing the restoration during this time.
Finishing:
- After the cement has set, remove any excess cement from the margins using a scaler or explorer.
- Polish the margins if needed for a smooth finish.
Post-Operative Care:
- Inform the patient about possible low sensitivity and provide any necessary aftercare instructions.